Sights for CZ P-10 Optics Ready

This collection contains iron sights for the CZ P-10 Optics Ready. They are made by Angry Bear in the USA, LPA in Italy and Night Fision in the USA.

Sights for the CZ P-10 Optics Ready

All sights in this collection are sets of front and rear sight.

Which sights to choose

• You use a red dot: co-witness sights. They are tall enough to see through the red dot window.
• You shoot with iron sights only: low sights. They sit close to the slide.
• You want to set the elevation: semi-adjustable sights. You set windage by moving the sight in the dovetail.

The sights in detail

• Co-witness sights from Angry Bear and Night Fision, in blank, fiber optic and tritium. They are taller than standard sights, so you see them through the window of a red dot on the slide.
• Low sights from Angry Bear, in blank, fiber optic and tritium. They sit close to the slide and suit shooting with iron sights only.
• Semi-adjustable co-witness sights from LPA, in fiber optic, luminescent dots and white dots. They are tall enough for a red dot and you set the elevation with a screw.

How to zero adjustable sights

Shoot a group at a fixed distance. Move the rear sight in the direction you want the point of impact to move: to the right to move hits to the right, up to move hits up. Turn the screw a few clicks at a time and shoot again.

Fit

• They do not fit the classic (non-OR) variants.

Sight picture

Fiber optic collects daylight and shines brightly at the range and in competition. Blank sights have a plain grooved surface without any marks. Luminescent dots charge in light and glow for a while in the dark. Tritium glows in the dark without charging. White dots give contrast without glowing.

Installation

Most pistol sights sit in a dovetail. You drift the old sight out and the new one in with a sight pusher or a punch. See Installation tools.

For red dot mounts, see Red dot mounts for CZ P-10. For all sights of this brand, see Sights for CZ models.

Frequently asked questions

Can I change the sights on my CZ P-10 Optics Ready at home?

Yes, with a sight pusher or a punch. Drift the old sight out of the dovetail and push the new one in. If you do not have the tool, a gunsmith can do it for you.

Which sights should I choose for my CZ P-10 Optics Ready?

It depends on how you shoot:

• You use a red dot: co-witness sights. They are tall enough to see through the red dot window.
• You shoot with iron sights only: low sights. They sit close to the slide.
• You want to set the elevation: semi-adjustable sights. You set windage by moving the sight in the dovetail.

Do these sights fit both the classic and the Optics Ready variant?

No. They do not fit the classic (non-OR) variants.