Optics ready plates for Kimber KDS9C

This collection contains optic plates for the Kimber KDS9C. The plate goes into the factory optic cut of the slide and takes the red dot on top. Every plate is made for one footprint or a group of footprints, so you choose it by the footprint of your red dot.

Plates for several footprints

• Impact Machine: Shield RMSc and Holosun K-series.

The type letters differ between makers. Always read the footprints in the brackets.

Material

Impact Machine makes its plates from steel.

Installation

Remove the cover plate from the optic cut, put the plate in and screw the red dot onto it. Use threadlocker on every screw. No milling and no gunsmith are needed.

Which red dot for which footprint

• Shield RMSc: Shield red dots, the Holosun EPS Core, Olight Osight K, S and SE and Vector Optics Frenzy-S. See Red dots with Shield RMSc footprint.
• Holosun K-series: the Holosun 407K and 507K, EPS Carry and SCS Carry. See Red dots with Holosun K-series footprint.

For all plates of this brand, see Optics ready plates for Kimber models.

Frequently asked questions

Can I install an optic plate on my Kimber KDS9C at home?

Yes. You need no gunsmith and no milling.

1. Remove the cover plate from the optic cut.
2. Screw the optic plate into the cut.
3. Screw the red dot onto the plate.

Put a drop of threadlocker on every screw.

Which red dots will fit my Kimber KDS9C?

It depends on the plate you choose. For the Kimber KDS9C we have plates for the Shield RMSc and Holosun K-series footprints. Choose your red dot, find its footprint in the specifications and take the plate with the same footprint.